1、设计方面，在制图人员拿到，脱硫、脱硝平台图纸后，要根据实际情况来确定，压锁钢格栅板的宽度，不应该出现宽度过大而出现拼接现象，如果是环形平台，应把钢格板拆分图设置为同一角度。这样后期加工及安装都将带来了方便。 2、注意塔设备平台钢格板的受力方向和钢格板的尺寸角度。如果压锁钢格栅板的受力方向和角度出现偏差的话在后期安装会出现安装不上的现象，环形脱硫、脱硝塔平台设计，扁钢方向一般为冲向圆心。 3、在打包运输途中。压锁钢格栅板注意打包要，按平台打包，不要混打，在有在运输中塔平台钢格板不像标准钢格板那样规矩，在运输途中就会出现摆放的问题，如果摆放不好发生了碰撞，或是编号出现混乱，就有可能对后期的安装导致不便。 4、注意后期保养。塔平台钢格板在安装和使用后，要注意的它的保养和维护，表面要保持清洁，这样可以延长压锁钢格栅板的使用寿命。
1. In the design aspect, after the drawings of desulfurization and denitrification platforms are obtained by the drawers, the width of pressure locking steel grilles should be determined according to the actual situation. The width of pressure locking steel grilles should not be too large and the splicing phenomenon should occur. If it is an annular platform, the splitting drawing of steel grilles should be set at the same angle. In this way, post-processing and installation will bring convenience. 2. Attention should be paid to the stress direction and dimension angle of the steel grille of tower equipment platform. If the force direction and angle of the pressure locking steel grille are deviated, the installation will not be able to be installed in the later stage. Ring desulfurization and denitrification tower platform design, flat steel direction is generally towards the center. 3. On the way of packing and transportation. Packing should be paid attention to the locking steel grille. Packing according to the platform, not mixing. In the transportation tower platform, the steel grille is not as regular as the standard steel grille. In the transportation process, there will be a problem of placement. If the placement is not good, collision occurs, or the number is confused, it may cause inconvenience to the later installation. 4. Pay attention to later maintenance. After installation and use, attention should be paid to its maintenance and maintenance, and the surface should be kept clean, so as to prolong the service life of pressure lock steel grids.